Bacharach Fyrite INSIGHT PLUS Instrukcja Obsługi Strona 83

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 82
Fyrite
INSIGHT
Plus Manual Operation
0024-9487 Rev 2 77
4.7.4. Stack Temperature Hot Spot Screen
Hot Spot
Component
Description
Hot Spot Graph
Press RUN/HOLD to start/stop
the hot spot function.
T-STACK parameter name
shown in graph.
Limits are determined
automatically.
Dynamic “current value” pointer indicates real-time value.
Color of “current value” pointer is based on limit status:
Black (Top): Hottest reading since last “Clear”
Red (Bottom): Current reading
Ideally, position probe so current reading (bottom) and
highest reading (top) match.
Left Arrow
Press the LEFT () arrow to go to the Bar Graph Screen.
Right Arrow
Press the RIGHT () arrow to go to the main RUN/HOLD
Screen.
Clear (F1)
Press the F1 button to clear the display and restart if in RUN
mode.
Menu (F2)
Press the F2 button to return to the Main menu.
4.8. Taking Ambient CO Measurements (Siegert Only)
This procedure takes approximately 15 minutes to complete and provides a
minute-by-minute snapshot of CO readings, as well as a “Max CO” value that
represents the highest CO reading measured during the entire 15-minute test.
Results can be saved to memory, downloaded, and/or printed. Use the
following procedure to perform an ambient CO measurement.
Step Example Procedure for Taking Ambient CO Measurements
1
Turn on the instrument in a fresh air environment and wait for
initialization to complete.
2
Verify successful initialization (no errors).
Przeglądanie stron 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 115 116

Komentarze do niniejszej Instrukcji

Brak uwag