Bacharach Informant 2 Dokumentacja

Refrigerant / Combustibles Leak Detector Instruction 0019-9211 Operation and Maintenance Rev. 9 – November 2012 Pat. 6,36

The Informant™ 2 6 0019-9211 Rev 9 NOTE: For dual detectors, the red probe tip will not screw onto a probe that has a refrigerant sensor instal

The Informant™ 2 0019-9211 Rev 9 7 2.4. Combustibles Sensor Installation Install the combustibles sensor, filter, and “red” probe tip onto the

The Informant™ 2 8 0019-9211 Rev 9 NOTE: During the warm-up period, the detector has zeroed out any background concentration of vapors or gases

The Informant™ 2 0019-9211 Rev 9 9 2.8. Locating a Gas Leak After the detector is turned on and allowed to warm up, observe that none of the ga

The Informant™ 2 10 0019-9211 Rev 9 CAUTION: When using the refrigerant sensor, note that exposing this sensor to a steady stream of highly con

The Informant™ 2 0019-9211 Rev 9 11 • use the detector in windy areas, • move the probe tip back and forth faster than 2" per second, • a

The Informant™ 2 12 0019-9211 Rev 9 • Always follow the refrigerant system around in a continuous path so that no areas of potential leaks are m

The Informant™ 2 0019-9211 Rev 9 13 3. MAINTENANCE 3.1. Introduction By following the procedures outlined below, The Informant 2 Leak Detecto

The Informant™ 2 14 0019-9211 Rev 9 Material Required: • Probe Filter (refer to Section Replacement Parts) Procedure: 1. Turn OFF detector

The Informant™ 2 0019-9211 Rev 9 15 3.5. Probe Assembly or Fan Replacement Replace the probe assembly or fan as follows (see Figures 5 thru 8):

The Informant™ 2 ii 0019-9211 Rev 9

The Informant™ 2 16 0019-9211 Rev 9 9. Turn ON the detector and check that it responds in a positive manner to a source of its corresponding g

The Informant™ 2 0019-9211 Rev 9 17 Figure 6. Front Retaining Collar Installation Figure 7. Fan Installation

The Informant™ 2 18 0019-9211 Rev 9 Figure 8. Connector Locations on Printed Circuit Board

The Informant™ 2 0019-9211 Rev 9 19 4. TROUBLESHOOTING The following table lists the causes and remedies for the most common problems that may

The Informant™ 2 20 0019-9211 Rev 9 Symptom Probably Cause and Remedy Short refrigerant sensor life. a. Probe filter dirty, thus not allowing en

The Informant™ 2 0019-9211 Rev 9 21 5. PARTS AND SERVICE 5.1. Complete Kits P/N Informant 2 Kit Contents 0019-8042 Dual Refrigerant/ Combust

The Informant™ 2 22 0019-9211 Rev 9 5.2. Optional Accessories P/N Informant 2 Kit Contents 0019-8037 Deluxe Upgrade Kit Protective rubber boo

The Informant™ 2 0019-9211 Rev 9 23 P/N Contents 0019-0499 Sensor: Combustibles 0019-0491 Soft Carrying Case 0019-0591 Battery Door Assembly

The Informant™ 2 24 0019-9211 Rev 9 6. Declaration of Conformity

The Informant™ 2 0019-9211 Rev 9 25 NOTES

The Informant™ 2 0019-9211 Rev 9 iii COMBUSTIBLE REFRIGERANT GAS WARNING: For your safety, DO NOT use the Informant 2 with the refrigerant sen

The Informant™ 2 26 0019-9211 Rev 9 NOTES

The Informant™ 2 0019-9211 Rev 9 27 NOTES

The Informant™ 2 28 0019-9211 Rev 9 World Headquarters 621 Hunt Valley Circle, New Kensington, Pennsylvania 15068 P

The Informant™ 2 iv 0019-9211 Rev 9 TABLE OF CONTENTS 1. OVERVIEW ...

The Informant™ 2 0019-9211 Rev 9 1 1. OVERVIEW 1.1. Introduction The Informant 2 Dual Refrigerant / Combustibles Leak Detector (Figure 1) is

The Informant™ 2 2 0019-9211 Rev 9 1.2. Features • Detects the presence of either refrigerants or combustible gases (with appropriate sensor i

The Informant™ 2 0019-9211 Rev 9 3 1.3. Technical Characteristics Specification Description Power Four ‘AA’ Alkaline Batteries Warm-Up Time 10

The Informant™ 2 4 0019-9211 Rev 9 Specification Description Switches Power ... Toggles detector ON/OFF Mute...

The Informant™ 2 0019-9211 Rev 9 5 2. OPERATION 2.1. Battery Installation WARNING: Explosion hazard. To reduce the risk of igniting a flamm